Products
Documentation
Articles

How to Install AccuLock S Liners Using Power Pin Cap With Set Screw

Installation With Set Screw Installation Without Set Screw(purchased before March 17, 2022) Step 1 A. Remove the nozzle B. Loosen the gas diffuser C. Remove the gas diffuser D. Loosen the set screw in the power pin cap and remove the cap from the rear of the gun. (Example of how to loosen the set […]

read more...

How to Repair the Cable on a BTB MIG Gun with a T Series Small Straight Handle

Remove consumables (Nozzle, Retaining Head, Contact Tip).Remove the liner from the gun.Mount neck in the vise.Disassemble handle and remove switch from leads.Move the handle back. Bend cable behind connector cone. Cut cable at bend.Slide two large “Oetiker” clamps 1.5 ft. down the cable (required for crimping later).From your cut (end of cable), measure 3” back […]

read more...

How to repair the cable on a MIG Gun with a T Series Straight Handle

Remove consumables (Nozzle, Retaining Head, Contact Tip). Remove the liner from the gun. Mount neck in the vise. Disassemble handle and remove switch from leads. Move the handle back.Bend cable behind connector cone. Cut cable at bend. Slide two large “Oetiker” clamps 1.5 ft. down the cable (required for crimping later). From your cut (end […]

read more...

How To Install or Replace a Euro Power Pin on a BTB Platform Gun

Remove liner and strain relief from the gun assembly. Disconnect the Euro block leads from the gun by cutting as close as possible on both sides of the butt connectors in order to preserve wire for later retermination. Slide adaptor nut toward cable, thus exposing the Euro block. Remove Euro block from end fitting using wrenches […]

read more...