Product Guide: Clean Air E™ – Changing Out the Hose

Need to replace the hose on your Clean Air E™ fume extraction gun? We’ve got you covered! Follow these simple steps to swap it out quickly and keep your fume extraction system performing at its best. Watch now and ensure clean, efficient welding every time.

Instructions

1. If replacing the vacuum hose assembly, remove all screws to separate the handle halves and remove the front hose swivel from its cavity.

2. Remove screw covers and two screws securing the rear handle, then slide the rear handle and strain relief backward to remove them.

3. Remove screws on the Y Connector and open to expose the cable assembly and rear hose swivel.

4. Pull the vacuum hose assembly backward to remove it from the cable assembly.

5. Slide the new vacuum hose assembly forward over the cable assembly until the front hose swivel rests in its cavity. Align the handle halves and reinstall all screws to retain hose assembly within handle.

6. With the cable straight, pull the hose and position it into the Y Connector, ensuring no slack. Tighten Y Connector screws, correctly positioning rubber boot within the Y Connector.

7. Slide rear handle and strain relief forward onto the cable assembly and secure with screws and screw covers.

Find more resources at www.startsatthesource.com